2.Wireless network CISCO PACKET TRACER

Wireless network CISCO PACKET TRACER

 
   Connect the network with a router To connect two different networks, we need a rounting, and the tool is called a router. In teoristis rightly so, and now we will try to build a different network with a router.

First, to build a network here we ONLY use simulations with PACKET TRACER

next, follow these steps;

 • Open your Packet Tracer

 • Put two switches, the routers, and four computers

 • Place two computers on the left and two on the right computer

 • Place the switch on the left and one on the right switch

 • Put the router in the middle

 • Use a straight cable to connect each computer to the switch

 • Use a straight cable to connect each switch to router Router IP  Address Setting:

 • Open your router confiq

 • At the FastEthernet 0/0 Fill

IP Address: 192.168.0.1/24 • FastEthernet 0/1 Fill In

IP Address: 192.168.1.1/24 Setting

IP Address Computer: For network 192.168.0.0 network (left) • Open your computer confiq input

IP Address: 192.168.0.2/24dan 0.3 / 24 • Click Settings, View Label Gateway, then Feedback

IP Address: 192.168.0.1 (Gateway is the IP address of the router (192.168.0.1) that connects between the router with the switch) To Network 192.168.1.0 • Open your computer conifiq input

IP Address: 192.168.1.2 and 1.3 • Click Settings, View Label Gateway, then Feedback

IP Address: 192.168.1.1 (Gateway is the IP address of the router (192.168.1.1) that connects between the router with the switch) Testing: • To check whether these two networks have been able to communicate, please do ping from

IP 192.168.0.2 to 192.168.1.2

Good luck okkey